Lasercutter: Trotec Speedy 400

The Laser is a 80 Watt Trotec Speedy 400. It has a build area of 100*60 cm. It is a CO2 Laser, here is a list of materials that can be cut.

 

Tech Specification

Engraving Area 1000 x 600 mm
Maximum Material Height  305 mm
Laser Wattage 80 watts
Laser Source State-of-the-art, digitally controlled, air-cooled CO2 laser tubes are fully modular, permanently aligned and field replaceable.
Air Assist Attached air compressor to remove heat and combustible gases from the cutting surface by directing a constant stream of compressed air across the cutting surface.
Red Dot Pointer Since the laser beam is invisible, the Red Dot Pointer on Speedy 400’s Laser allows you to have a visual reference for locating where the laser will fire.
Relocatable Home When engraving items that are not easily placed at the top corner of the laser, you can set a marker by hand with the Job Control Software.
Operating Modes Optimized raster, vector or combined modes.
Motion Control System High-speed micro stepper motors.
Resolution  User controlled from 125/250/333/500/600/1000dpi
Speed and Power Control Computer or manually control speed and power in 1% increments to 100%. Vector color mapping links speed, power and focus to specific RGB color.
Print Interface USB Connection.